.

Recent Posts

Pages: 1 ... 8 9 [10]
91
General Discussion / Re: Wheel Question
« Last post by rand22 on May 08, 2014, 07:06:45 PM »
I am honestly considering it now rob.... might be the only way.
92
General Discussion / Re: Fender rolling.
« Last post by IvanDK27 on May 08, 2014, 05:22:40 PM »
 Problem fixed, thanks for the support.
93
DIY mods / Re: N54 6MT Transmission Fluid Change
« Last post by e90nate on May 08, 2014, 08:56:17 AM »
thanks man, my friends 335i 6 speed has a slow leak/sweating
94
Wanted / Cooling Mist CM14 Nozzle
« Last post by Rob.K on May 07, 2014, 02:54:43 PM »
Looking for a CM14 Injector Nozzle, anyone have one by chance?

95
DIY mods / Re: N54 6MT Transmission Fluid Change
« Last post by Rob.K on May 07, 2014, 12:00:34 PM »
rob would this diy also be a good starting point to change trans output shaft and shift rod seal?

I haven't done any trans seals in a vehicle before but I would think that it would be substantially more work. I'll look into it for you though :)
96
Photo/Video/Media Gallery / 2008 135i Baseline Dyno
« Last post by Rob.K on May 07, 2014, 11:22:46 AM »
Well I finally got around to taking everything off the car to do some baseline dyno pulls.
I'm rather surprised at the numbers!  :D I was expecting around the 280whp mark!

Looking forward to having the car FBO + Meth and then going for another couple dyno pulls  :)

2008 135i Baseline Dyno


97
General Technical / Re: e46 CEL
« Last post by YYCZHP on May 06, 2014, 08:03:02 PM »
Thanks guys, will check it out tomorrow!
98
General Discussion / Fender rolling.
« Last post by IvanDK27 on May 06, 2014, 06:05:19 PM »
 Hi everyone, I'm new to this site, just put on 18" m6 reps on my e46 sedan, they look awesome but the rears are 265's and they rub a bit when doing sharp turns or bumpy roads (everywhere in edmonton) my shocks are new, so that ain't the problem...

 Need help finding a shop to roll my fenders or maybe rent the tool?? any suggestions are welcomed.

 thanks.
99
DIY mods / Re: N54 6MT Transmission Fluid Change
« Last post by e90nate on May 05, 2014, 02:42:59 PM »
rob would this diy also be a good starting point to change trans output shaft and shift rod seal?
100
For Sale / Re: BMS pre-LCI LED angel eyes
« Last post by TDHartog on May 04, 2014, 01:04:25 PM »
bump
Pages: 1 ... 8 9 [10]